R&S NRX-B4, User Manual

Page: 211 / 450

Remote Control Commands
R&S
®
NRX
211 User Manual 1178.5566.02 ─ 05
Parameters:
<hysteresis> Range: 0.0 to 10.0
*RST: 0.0
Default unit: dB
Manual operation: See "Hysteresis" on page 58
TRIGger<Measurement>[:CHANnel<Channel>]:JITTer:METHod <method>
Defines the method how to cope with the misalignment between the trigger event and
the sample point.
Suffix:
<Measurement>
.
1 to 4
Measurement channel
<Channel> 1 to 2
1 = primary sensor, 2 = secondary sensor
Parameters:
<method> COMPensate | MEASure | NONE
COMPensate
Compensation means resampling of trace result.
MEASure
Does not perform resampling, but stores the measured trigger
jitter.
*RST:
COMPensate
Manual operation: See "Jitter Suppression" on page 59
TRIGger<undef>:ALL:LEVel <level>
TRIGger<Measurement>[:CHANnel<Channel>]:LEVel <level>
Effective only if
TRIGger<Measurement>[:CHANnel<Channel>]:SOURce
INTernal
.
Sets the trigger threshold for internal triggering derived from the test signal.
If you enter a value without unit, the unit is defined by
UNIT<Measurement>:
POWer[:VALue]
. For further information, see Chapter 14.4.1.3, "Units" , on page 188.
The command is not fully R&S NRP2 compatible. If port 1 is assigned to measure-
ment 1 and so on, the command works. If port 1 is assigned to measurement 2, for
example, enable the R&S NRP2 emulation using
SYSTem:LANGuage "NRP2"
.
Suffix:
<Measurement>
.
1 to 4
Measurement channel
<Channel> 1 to 2
1 = primary sensor, 2 = secondary sensor
Measurement Settings and Results