1. OPERATION
1-70
1. Right-Click the transmit icon ([TX] or [STBY]) to open the [TX STBY] menu.
2. Click [PROPERTY] to open the [PROPERTY] window.
• [ON TIME]: Total operation time
• [TX TIME]: Total transmission time
• [TRON TIME]: Total magnetron usage time
1.39.6
How to select the installation settings
If several installation configurations were saved at installation, you can select the ap-
propriate configuration according to your situation.
Below are some examples of situations which may require a change the configuration.
• The antenna is installed on a barge (or similar vessel) and the location of the anten-
na changes or the length the cable changes.
• Your system configuration has two antennas and one processor unit, and the an-
tennas are swapped.
1. Click [INSTALLATION] to open the [INSTALLATION] menu.
2. Click the appropriate installation setting, [INSTALL 1] to [INSTALL 4].
Note:
Where the system uses an interswitch to control two antennas, do not use this
method to change configurations. Your configuration settings may be lost if the exter-
nal antenna is in use when this method is used.
Transmit icon
(at the top left corner on the screen)
Right-
click
SEA
ROT
RUDDER
4 /1 NM
HEAD-UP
RD003001
TX
OFFCENT
HDG
MASTE
A
M1
OFF
[TX
STBY]
1 BACK
2 [PROPERTY]
[PROPERTY]
1 BACK
ON
TIME
000013. 5H
TX
TIME
000011. 9H
TRON
TIME
000011. 9H
Click
FTC 1
IR 1
ES 2
EAV 3
TRAIL
►
2.50sec
00m03s
REL
ON
CUSTOM3-4
►
CUSTOM3-4
►
INSTALL 1
►
INSTALL 1
►
[INSTALLATION]
1 BACK
2 INSTALLATION
INSTALL1/
INSTALL2/
INSTALL3/
INSTALL4
