Rackable Systems OmniStor 4900F Series, User Manual

Page: 101 / 196

Chapter 3 - Setup and Installation
Multi-Port Mirrored Single Host-Dual Connection Configuration
87
6
Connect the Fibre Channel data cable(s).
a
Connect a cable from the host first HBA FC port to the “H0” connector on
the right Host I/O card.
b
Connect another cable from the host second HBA FC port to the “H1”
connector on the left Host I/O card. Refer to the illustration below.
Multi-Port Mirrored Single Host-Dual Connection Cabling Diagram
7
(Embedded StorView only) Connect a CAT 5e ethernet cable from the RAID
Controller network port to your ethernet switch or LAN. Connect a second
CAT 5e ethernet cable from the second RAID Controller to another network
connection.
8
If you wish to add additional enclosure(s), follow the instructions below.
Otherwise skip to step 14. The example depicts one extra enclosure being added,
however, you may wish to add more enclosures up to the allowable limit of 96
drives.
9
Set the jumper (JP4) on the Disk I/O card installed in the expansion enclosure.
Loosen the two captive fastener screws on the Disk I/O card and pull it from the
daisy-chain enclosure using the fastener screws. Locate the jumper JP4 and
position it for the desired speed setting, (installed on one pin only for 2 Gb mode
and on both pins for 1 Gb mode).