![background image](http://html2.mh-extra.com/html/quantum/dxi4700/dxi4700_user-manual_3524678261.webp)
Chapter 9: Configuration
Replication Configuration
Quantum DXi4700 User’s Guide
261
l
To show or hide a column, click the arrow to the right of a column heading, and then click
Columns
.
Select the check box to show a column, or clear the check box to hide a column.
Note:
The statistics in the
Source DXis
list are for each source DXi rather than a cumulative total for
all sources as is displayed on the
Home
page.
Adding a Replication Source
Add a system to the list of replication sources to allow it to send replicated data to the DXi4700. You must
add a source system to the list of allowed replication sources on the target DXi before you configure the
source DXi to send replicated data to the target. The DXi can receive replicated data fromup to 10 sources.
Additional Information
l
For more information about working with received snapshots, see
l
It is typical for the target DXi to require additional disk space for replication data compared to the
source DXi. This is because complete replication data is sent to the target before old data is deleted.
For optimal performance, if the DXi is a replication target, Quantum recommends keeping the amount
of free space at 20% or more (see
).
To add a replication source:
1. Under
Source DXis
, click
Add
.
The
Add Allowed Source
).
Figure 163:
Add Allowed Source
2. In the
Source Hostname or IP
box, enter the hostname or IP address of the system that will send the
replicated data to the DXi4700.
Note:
To use hostname format, you must specify at least one DNS IP address on the
Network
).
3. Click
Apply
.