Chapter 9: Configuration
System
Quantum DXi4700 User’s Guide
298
Figure 186:
Network Page: Routing Details
1. In the
IP Address Table
(above routing details), select an interface to add or modify routing data. (To
select an interface, click the radio button next to the interface index name, for example,
bond0:2
.)
After selecting an interface in the
IP Address Table
, the
Routing Details
table below expands to
display available routes (if any).
Note:
A maximum of 8 routes per interface are allowed.
2. If necessary, click the
Show
link to show the routing details table.
3. Click
Add Route
to add a route to the selected interface.
Or select a route to edit its settings.
4. Enter the following network information as provided by your network administrator:
Destination
The destination network for the route.
Dest Netmask
The network mask for the route.
Dest Gateway
The gateway IP address used for
outgoing
traffic sent from the interface to a host or
client. (This is usually not the same as the default gateway.)
Additional Information
l
The destination gateway of each route
must
match the subnet of at least one configured IP
address listed in the
IP Address Table
. If no match is found, an error displays stating that the
route’s destination gateway is not reachable.
l
In the example shown below, to reach a host on the 10.50.50.x subnet, you would enter
10.50.50.0 for destination network, 255.255.255.0 for the destination netmask, and 10.20.20.1 as
the destination gateway.
5. Click
Update
to save the changes you made to the
Routing Details
table. (Clicking
Update
does not
yet apply the new network settings to the DXi4700.)
6. Click
Delete
to remove IP routing information for the selected interface. Or click
Undo
to revert all
current Routing Details changes to the last update.