Chapter 9: Configuration
System
Quantum DXi4700 User’s Guide
301
Example 3: Segments on the Same Subnet and Target on a Different Subnet
), the DXi has two segmented interfaces, one for data and
management traffic, and one for replication traffic:
l
The source DXi management/data IP address and the source DXi replication IP address are on the same
subnet (192.168.10.x). The target DXi IP address is on a different subnet (192.168.20.x)
l
To make sure the replication segment is used when communicating with the target DXi, you must add a
network route in the
Routing Details
section on the source DXi.
In this example, you would specify the following routing details for the replication interface on the source
DXi:
Destination
Use the subnet of the target DXi (192.168.20.0).
Dest Netmask
Use 255.255.255.0.
Dest Gateway
Use the IP address of the gateway (192.168.10.1).
l
In addition, to enable communication with the target DXi by means of the gateway, you must add a
second host route in the
Routing Details
section on the source DXi.
In this example, you would specify a second set of routing details for the replication interface on the source
DXi:
Destination
Use the IP address of the gateway (192.168.10.1).
Dest Netmask
Use 255.255.255.255.
Dest Gateway
Use the replication IP address of the source DXi (192.168.10.100).
Backpanel Locations
The
Backpanel Locations
section at the bottom of the
Network
page displays a graphical representation
of the Ethernet ports as they appear on the rear of the system (see
).
The diagram indicates the current bonding configuration and connectivity status for all Ethernet ports.
l
Ports that are bonded together in an interface are shaded the same color.
l
A green border indicates a port is connected to a network.
l
A red border indicates a port is configured but is not connected to a network.
l
Click
Update Port View
to update the information on the diagram.
