Figure 19 Pilot rail front attachment
Legend
1 Back
2 Four-hole spacer bars
3 Front
4 Slider lock nuts
4 Use two 10-32 Torx Washer Head screws to secure the rail through the
rack into the two center holes in the spacer bar.
The top and bottom holes are use to secure the Pilot control units to the rack.
5 At the back of the frame, place a spacer on a 10-32 Torx Washer Head
screw and screw it through the hole in the frame and into the rail under the
scope hook.
Install the second screw the same way. Ensure that the spacer is centered
inside the rack's square mounting hole.
6 Repeat Steps 1 through 5 for the other side rail.
7 Tighten the four slider lock nuts that attach each rail scope to the rail.
Slammer Rail Kit Parts
Verify that the rail kit contains all the parts listed in the table below.
Chapter 2 Set Up the Rack
About Component Placement
53
