WMS-308N Network Access Control Gateway
User's Manual
40
4.2.3 Configure SNMP
SNMP is an application-layer protocol that provides a message of format for communication between SNMP
managers and agents. By enabling SNMP function, the administrator can obtain the system information remotely.
Please click on
System -> SNMP Setup
and follow the below setting.
SNMP v2c Enable :
Check to enable SNMP v2c.
Î
ro community :
Set a community string to authorize read-only access.
Î
rw community :
Set a community string to authorize read/write access.
SNMP v3 Enable :
Check to enable SNMP v3.
SNMPv3 supports the highest level SNMP security.
Î
SNMP ro user :
Set a community string to authorize read-only access.
Î
SNMP ro password :
Set a password to authorize read-only access.
Î
SNMP rw user :
Set a community string to authorize read/write access.
Î
SNMP rw password :
Set a password to authorize read/write access.
SNMP Trap :
Events such as cold start, interface up & down, and association & disassociation will report to an
assigned server.
Î
Community :
Set a community string required by the remote host computer that will receive trap messages
or notices send by the system.
Î
IP :
Enter the IP addresses of the remote hosts to receive trap messages.
Change these settings as described here and click
Save
button to save your changes. Click
Reboot
button to
activate your changes
