WMS-308N Network Access Control Gateway
User's Manual
116
4.5.2 IP Filter
The administrator can setting IP Filter via this page, Please click on
Advance -> IP Filter
and follow the below
setting.
Source Address/Mask :
Enter the desired source IP address and netmask; the mask must be a plain number,
i.e. 192.168.100.10/32
Source Port :
The source port(s) required for this rule. A single port may be given, or a range may be given as
start:end
, which will match all ports from
start
to
end
, inclusive.
Destination Address/Mask :
Enter the desired destination IP address and netmask; the mask must be a plain
number, i.e. 192.168.1.10/32
Destination Port :
The destination port(s) required for this rule. A single port may be given, or a range may be
given as
start:end
, which will match all ports from
start
to
end
, inclusive.
In/Out :
This option used for specialized packet alteration. The system support In (INPUT : for packets coming
into the interface itself) or Out (FORWARD : for altering packets being routed through the interface)
Protocol :
This option allows you to select protocol type. The system support TCP, UDP or ICMP.
Listen :
Enable
Yes
to match TCP packets only with the SYN flag.
Policy :
Enter
Deny
to DROP specialized packet;
Pass
to ACCET the specialized packet
Interface :
Select specified interface where filtering of the incoming /passing-through packets is processed
Schedule :
Select specified time period for this rule.
Click “
Save
” button to add IP filter rule to List. There are
20
rules maximum allowed in this IP Filter List. All rules can
be
edited
or
removed
on the List. Click
Reboot
button to activate your changes.
