Perma Distributor PRO MP-6, Operating Instructions Manual

Page: 61 / 80

perma PRO MP-6 Distributor - 10 -
Separate Mounting of Distributor and Lubricator
Separate mounting of the distributor and the lubricator is possible.
For this, perma-tec offers an additional mounting device, the necessary tube connections and a longer con-
necting cable (refer to “Accessories and Spare Parts”).
Attach the lubricator of the PRO range to your system as described in its Operating Instructions and mount the
distributor as follows:
♦ Attach the mounting device to the distributor using the enclosed hex head bolts (M6 x 16) and the washers.
♦ Screw the mounting device with the distributor onto a support of your system.
For the bore position of the four fi xing screws refer to fi gure 7 below. At least four hexagon screws M6 x 25
must be used (e.g. on metal ground).
♦ Before you connect the outlets of the distributor to any grease lines and hoses you have to pre-lubricate all
lubrication points and pre-fi ll all grease lines with the same lubricant that is contained in the PRO LC unit
of the lubricator. For that, perma-tec offers a 400 g lubrication cartridge for manually-operated grease presses
with the requested lubricant.
♦ Fit the reducer coupling G3/8i to G1/8i f. tube oØ 8 mm (Part no. 101545) and the tube connector G1/8o
for tube oØ 8 mm straight (Part no. 101570) on the lubricator.
♦ Fit the tube connector G3/8o for tube oØ 8 mm straight (Part no. 101498) on the distributor.
♦ Connect the distributor to the PRO lubricator with the grease line. Maximum tube length 2 meters (Ø 8 x 1.5,
inner-Ø 5 mm).
♦ Connect the grease lines to the connections of the distributor and install them correctly between the
distributor and the lubrication point. The grease line between lubricator, distributor and lubrication point
must not exceed a total length of 5 meters (for details about temperature and lubricant please refer to
operating instructions of PRO/PRO C chapter 3, chart 1).
♦ Fit the ends of the grease lines with the required tube connections.
♦ While the lubrication system is switched off , connect the lubricator to the distributor with the connecting
cable (long).
♦ The lubrication system is now ready for operation.
Ensure correct and tight assembly of the connections and grease lines to avoid possible leakage.
75
45
fi gure 7
2 hexagon screws
M6 x 25 (for wall
mounting on metal)
2 hex head bolts
M6 x 16, maximum
torque 3 Nm
(for attaching the
distributor to the
mounting device)
2 hexagon screws
M6 x 25 (for wall
mounting on metal)