Pentair FLECK 3150 NXT, Installer Manual

Page: 93 / 182

Installer manual Fleck 3150 NXT/NXT2 - Programming
Ref. MKT-IM-010 / C - 18.10.2019 93 / 182
Parameter Options Definition Note
AUXILIARY 1 STANDBY Activates relay from beginning of
regeneration and during standby
phase.
OFF (default)
ALARM
BASED
- Any alarm or error detected by
the controller will start signal
output from Auxiliary relay#1.
CYCLE
BASED
-
TIME
BASED
-
VOLUME
BASED
- This choice will only available
when metered regeneration
type.
AUX. 1: CYCLE
BASED
SP Service position Only displayed if “Cycle based”
is chosen for auxiliary 1;
Activate or de-activate for each
position ( = deactivated;
= activated).
BW Backwash position
BD Draw and slow rinse
position
RR Rapid rinse position
RF Refill position
SB Pause position
AUX. 1: TIME
BASED - START
TIME #1
0 to total
regeneratio
n time
minus
1 minute
Minute Only displayed if “Time based” is
chosen for auxiliary 1.
AUX. 1: TIME
BASED - END
TIME #1
from start
time#1 plus
1 minute
until total
regeneratio
n duration
Minute
AUX. 1: TIME
BASED - START
TIME #2
OFF
End time #1
to total
regeneratio
n duration
minus
1 minute
Minute Only displayed if “Time based” is
chosen for auxiliary 1 and END
TIME #1< total regeneration
duration minus 1 minute;
Range depend on Start and end
time #1 values.