Pentair FLECK 3150 NXT, Installer Manual

Page: 86 / 182

Installer manual Fleck 3150 NXT/NXT2 - Programming
86 / 182 Ref. MKT-IM-010 / C - 18.10.2019
Info
For a timeclock valve, this value must be set. For metered valves, calendar override
parameter would trigger a regeneration only if the volumetric control did not start a
regeneration before calendar override period elapsed. Each volumetric regeneration
happening reset the calendar override delay.
Calendar override is not visible in «Day of the week» mode.
a) Press and hold and simultaneously to enter
user programming mode.
b) Select the number of days or hours with and .
c) Press to validate the selection and advance to the
next parameter.
ð Can be adjusted with 4H, 8H, 12H, 16H, 20H or
from 1 to 99 days for timeclock regeneration and
from OFF to 99 days for metered regeneration.
Without calendar
override.
Override every 3 days.
6.2.4.3 Regeneration time
Set the time for regeneration start.
Mandatory
It must be set when the regeneration mode programmed is timeclock, day of week
mode, volumetric delayed mode and any time a calendar override period is set.
a) Adjust the time with and .
b) Press to validate the selection and advance to the
next parameter.
6.2.4.4 Hardness
Set the inlet water hardness in the unit defined on chapter Units [ } Page 101].
Info
This parameter is not visible in "Filter " mode.
a) Adjust the hardness with , and .
b) Press to validate the selection and advance to the
next parameter.
6.2.4.5 Volume remaining
Display the remaining volume before the system's capacity is exhausted. This
parameter can be adjust if necessary, and will be reset to the programmed capacity
after next regeneration.