Panasonic PT-SRZ34KC, Operating Instructions Manual

Page: 208 / 322

Chapter 4 Settings
—
[SECURITY] menu
20 8 - ENGLISH
[SECURITY] menu
On the menu screen, select [SECURITY] from the main menu, and select an item from the sub-menu.
Refer to “ Navigating through the menu ” (
x
page 96) for the operation of the menu screen.
f
When the projector is used for the fi rst ti m e
Initial pass w ord: Press
awsqawsq
in order, and press the <
执行
> button.
Attention
f
When you select the [SE C URITY] m enu and press the <
执行
> button, entering a pass w ord is pro m pted. Enter the preset pass w ord and
then continue operations of the [SE C URITY] m enu.
f
When the pass w ord has been changed pre v iously, enter the changed pass w ord, and press the <
执行
> button.
Note
f
The entered pass w ord is displayed w ith * m arks on the screen.
f
An error m essage is displayed on the screen w hen the entered pass w ord is incorrect. Re-enter the correct pass w ord.
[SECURITY PASSWORD]
Display the
[SECURITY PASSWORD]
screen w hen the po w er is turned on w ith the <
主电源
> s w itch set to the
<
关
> side. When the entered pass w ord is incorrect, the operation w ill be restricted to the po w er standby <
v
>
button, the <
快门
> button, and the <
镜头
> buttons ( <
聚焦
>, <
变焦
>, <
移位
> ) .
1) Press
as
to select [SECURITY PASSWORD].
2) Press
qw
to switch the item.
f
The ite m s w ill s w itch each ti m e you press the button.
[OFF]
Disables the security pass w ord entry.
[ON] Enables the security pass w ord entry.
Note
f
The [SE C URITY PASSWORD] setting is set to [OFF] by the factory default setting, or after initialized by one of the follo w ing m ethods.
g
When initialized by selecting the [PROJE C TOR SETUP] m enu → [INITIALI Z E] → [FA C TORY RESET]
g
When initialized by setting the [PROJE C TOR SETUP] m enu → [INITIALI Z E] → [USER SETTINGS] → [OTHER USER SETTING] to
[INITIALI Z E]
f
C hange the pass w ord periodically that is hard to guess.
f
The security pass w ord is enabled after setting [SE C URITY PASSWORD] to [ON] and turning the <
主电源
> s w itch to <
关
>.
[SECURITY PASSWORD CHANGE]
C hange the security pass w ord.
1) Press
as
to select [SECURITY PASSWORD CHANGE].
2) Press the <
执行
> button.
f
The [SECURITY PASSWORD CHANGE] screen is displayed.
3) Press
asqw
and the number (<0> - <9>) buttons to set the password.
f
Up to eight button operations can be set.
4) Press the <
执行
> button.
5) Re-enter the password for the confirmation.
6) Press the <
执行
> button.
Note
f
The entered pass w ord is displayed w ith * m arks on the screen.
f
When nu m erical v alues are used for the security pass w ord, the security pass w ord is required to be initialized if the re m ote control is lost.
C onsult your dealer for the m ethod of initialization.
[CONTROL DEVICE SETUP]
Enable / disable the button operations on the control panel and the re m ote control.
1) Press
as
to select [CONTROL DEVICE SETUP].