Panasonic PT-SRZ34KC, Operating Instructions Manual

Page: 185 / 322

Chapter 4 Settings
—
[PROJECTOR SETUP] menu
ENGLISH - 1 85
maximum value that can be set.
12) Adjust [LIGHT OUTPUT] of each projector.
f
Adjust [LIGHT OUTPUT] of all the other projectors so that the brightness w ill be the sa m e as the projector
w ith the least brightness.
13) Set [CONSTANT MODE] of [BRIGHTNESS CONTROL SETUP] to [AUTO], and [LINK] to [GROUP A] in
all projectors.
14) Select [APPLY] of [BRIGHTNESS CONTROL SETUP] and press the <
执行
> button in all projectors.
f
Brightness control starts.
Note
f
Brightness is auto m atically corrected w hene v er the light source lights up by s w itching on / off the projector, etc.
f
When the v ariation in brightness has increased due to aging of the light source, or w hen you replaced the light source, readjust the
brightness control.
[NO SIGNAL SETTING]
Set the operation of the function w hen there is no input signal.
[BACKUP INPUT SETTING]
Set the backup function that s w itches the signal to the backup input signal as sea m less as possible w hen input
signal is disrupted.
1) Press
as
to select [NO SIGNAL SETTING].
2) Press the <
执行
> button.
f
The [NO SIGNAL SETTING] screen is displayed.
3) Press
as
to select [BACKUP INPUT SETTING].
4) Press the <
执行
> button.
f
The [BACKUP INPUT SETTING] screen is displayed.
5) Press
as
to select [BACKUP INPUT MODE].
6) Press the <
执行
> button.
f
The
[BACKUP INPUT MODE]
screen is displayed.
7) Press
as
to select the combination of the input and press the <
执行
> button.
Primary input Secondary input Details
[OFF] Disables the backup function.
[SDI] [HDMI]
Enables the backup function.
[SDI] [DVI-D]
[HDMI 1 [SLOT]]
* 1
[HDMI 2 [SLOT]]
* 1
[DVI-D 1 [SLOT]]
* 1
[DVI-D 2 [SLOT]]
* 1
[SDI 1 [SLOT]]
* 1
[SDI 3 [SLOT]]
* 1
* 1 This is displayed w hen the optional Interface Board equipped w ith corresponding input is installed in <SLOT>.
8) Press the <
菜单
> button.
f
The
[BACKUP INPUT SETTING]
screen is displayed.
9) Press
as
to select [AUTOMATIC SWITCHING].
f
When [BA C KUP INPUT MODE] is set to [OFF], [AUTOMATI C SWIT C HING] cannot be selected.
10) Press
qw
to switch the item.
f
The ite m s w ill s w itch each ti m e you press the button.
[ENABLE]
S w itches to the secondary input ( pri m ary input ) auto m atically w hen the input signal for pri m ary input
( secondary input ) is disrupted.
[DISABLE] Disables the auto m atic input s w itching function.