Refresh interval [1fps, 4fps, 5fps, 12fps, 12.5fps, 15fps,
24fps, 25fps, 30fps]
Select the frame rate for JPEG images.
59.94Hz
1fps/5fps/15fps/30fps
50Hz
1fps/5fps/12.5fps/25fps
24/23.98Hz 1fps/4fps/12fps/24fps
Factory settings:
For 59.94Hz:
JPEG(1): 30fps
JPEG(2): 5fps
JPEG(3): 30fps
For 50Hz:
JPEG(1): 25fps
JPEG(2): 5fps
JPEG(3): 25fps
For 24/23.98Hz:
JPEG(1): 24fps
JPEG(2): 4fps
JPEG(3): 24fps
<NOTE>
• The frame rate may be slower depending on the network
environment, resolution, image quality, access volume, etc.
• If images are not transmitted at the specified frame rate, lowering
the resolution or image quality may result in transmissions closer to
the specified value.
Image quality [Fine, Normal]
Specify the JPEG image quality for each resolution.
Factory settings:
Fine
z
H.264
Set H.264 image settings.
The setting is confirmed with the [Set] button.
<NOTE>
• On browsers other than Internet Explorer 11, only JPEG images can
be displayed.
• Only [H.264(1)] can be set when the [Streaming mode] is
[H.264(UHD)].
• H.264 cannot be set when the [Streaming mode] is [H.265(UHD)],
[H.265], [SRT(H.265)], [SRT(H.265 UHD)], [NDI|HX] or [High
bandwidth NDI].
• When starting RTSP/RTP transmissions, set the following URLs for
the decoders and applications.
- For H.264(1):
rtsp://[unit’s IP address]/MediaInput/h264/stream_1
- For H.264(2):
rtsp://[unit’s IP address]/MediaInput/h264/stream_2
- For H.264(3):
rtsp://[unit’s IP address]/MediaInput/h264/stream_3
- For H.264(4):
rtsp://[unit’s IP address]/MediaInput/h264/stream_4
[/MediaInput/h264/stream_
*
] can be changed in [RTSP] of
[Advanced].
(→ page 147)
H.264 transmission [On, Off]
Whether to transmit the H.264 images is set here.
Factory settings:
On
Internet mode(Over HTTP)
[On, Off]
This setting is selected when transmitting H.264 images over the
Internet.
H.264 images can be transmitted using the same broadband router
settings as when transmitting JPEG images.
On
The H.264 images and audio are transmitted using the
HTTP port. For details on setting the HTTP port number,
refer to page 142.
Off
The H.264 images and audio are transmitted using the
UDP port.
Factory settings:
Off
<NOTE>
• When [On] is set, only [Unicast port(AUTO)] can be selected as the
[Transmission type] setting.
• When [On] is set, it takes a few seconds before the H.264 images
are displayed.
• When this is set to [On], access will be limited to IPv4.
• This function is only reflected in the H.264 images displayed in the
live screen [Live].
112
113
Web screen configurations (continued)
