Main Mode: Using the Unit Connected to a Network
73
M
a
in M
o
de
You can check the network connection status of an FTP client.
Checking the connection (PING)
1
Display the thumbnail screen.
2
Press the [MENU] button to display the menu.
(
➝
“Menu Operations” page 89)
3
Use the up or down cursor button to align the cursor
with the “PING” (
➝
page 108) menu item and press
the [SET] button.
4
Check the connection status for the set address.
When a connection is confirmed, “PING SUCCESSFUL!”
appears.
“PING FAILED!” appears if a connection cannot be estab-
lished within approximately 30 seconds. Use the log de-
scribed in the next section to determine the cause of the
failure.
Viewing the connection log (LOG)
1
Press the [MENU] button to display the menu.
(
➝
“Menu Operations” page 89)
2
Use the up or down cursor button to align the cursor
with the “LOG DISPLAY” (
➝
page 108) menu item
and press the [SET] button.
Check the information in the log.
3
After you finish checking, press the [EXIT] button to
return to the menu.
Note:
• Some operations may not generate any information in the log.
• The password is indicated as “
” in the log.
Status display
1
Press the [MENU] button to display the menu.
(
➝
“Menu Operations” page 89)
2
Use the cursor buttons to align the cursor with the
“STATUS DISPLAY” (
➝
page 108) menu item and
press the [SET] button.
The connection status appears.
3
After you finish checking, press the [EXIT] button to
return to the menu.
Note:
• The status information is not updated in real-time. To view
the most recent information, perform the steps above again.
• When “DHCP” is set to “ENABLE,” the values may differ from
those of ordinary LAN settings.
• When “DHCP” is enabled, the status information is not displayed
correctly while the address information is being obtained.
• The default gateway is not displayed as status information if
it is not set correctly.
• If only SECONDARY DNS is set and PRIMARY DNS is not set
in the LAN settings, the DNS is indicated as “DNS1.”
Initializing the network settings (INITIALIZE)
1
Press the [MENU] button to display the menu.
(
➝
“Menu Operations” page 89)
2
Use the cursor buttons to align the cursor with
“NETWORK TOOLS” - “INITIALIZE” (
➝
page 108)
and press the [SET] button.
The menu reappears when initialization is completed.
Operation check tools, status indication,
and initialization
