72
Main Mode: Using the Unit Connected to a Network
Starting the application (P2 Browser) from the Web browser
When the network connection with the mobile device or computer is established, start the browser on the mobile device or com-
puter and then start the application (P2 Browser).
1
Select “BROWSE” or “CTRL)” in the
“HTTP SERVER” (
➝
page 105) menu setting.
The P2 Browser function is enabled.
2
Start the browser (Safari or Internet Explorer) on the
mobile device or computer.
3
Enter the IP address set for the unit in the address
bar of the browser.
• Factory default setting: 192.168.0.1
4
Press the Enter key in the case of a computer and tap
the GO button in the case of an iPad or iPhone.
The Web application (P2 Browser) starts.
5
Enter the user name and password in the input screen.
Enter the value set for “USER ACCOUNT" (factory default
setting: guest) and the value set for “PASSWORD” (factory
default setting: p2guest) on the unit.
The connection is established when the screen in Figure 1
appears.
You can set a user account name and password in the
“USER ACCOUNT” (
➝
page 105) menu setting.
You can register a new account, delete an account, or
change a password in the “ACCOUNT LIST” (
➝
page 105)
menu setting.
The user account name can be up to 31 characters long
and the password can be from 6 to 15 characters long.
For information on P2 Browser, refer to Operating Instruc-
tions of P2 Web Application available from the following
website.
http://pro-av.panasonic.net/en/manual/index.html
Note:
• When “NETWORK SEL” is “WLAN,” “4G/LTE,” or “LAN,” the
startup time when the power is turned on may be longer than
usual due to the network function starting.
• When “NETWORK SEL” is set to “OFF,” the network function will
not be available.
• When the “NETWORK SEL” setting is changed, the change is
not applied until the unit is restarted. When the setting is
changed, it may take a while for the settings screen to close be-
cause the network service is restarted.
• The combination of the IP address, subnet mask, and default
gateway must be correct.
If the “CANNOT ACCESS GATEWAY!” warning appears as the
setup screen closes, contact your network administrator.
• When a default gateway and DNS will not be used, set the set-
tings to “0.0.0.0.”
• DHCP and DNS may not operate properly in some network en-
vironments.
The following functions are supported.
• Editing/saving playlists
• Creating new clips from playlists (edit copy)
• SDI playback using playlists
• Displaying and editing metadata
• Adding and deleting metadata (shot marks and text mem-
os)
For how to change modes and other information, refer to “P2
Playlist Editing Mode” (
➝
page 83).
Network Functions
P2 Browser Function
Figure 1
P2 Playlist Editing Functions
