Oracle X5-2L, Service Manual

Page: 173 / 324

Install SAS Storage Drive Cables
Servicing FRUs 173
Route the SAS cable bundle through the chassis mid-wall and along the right side of the
chassis.
2.
Reconnect the SAS cables.
a.
To reconnect the SAS cables between the front storage drive backplane and
the Oracle Storage 12 Gb/s SAS PCIe RAID HBA card, plug each cable into
its SAS connector until you hear an audible click [1].
See also “Install the Oracle Storage 12 Gb/s SAS PCIe RAID HBA Card” on page 184 .
Use the following table to ensure proper SAS cable connections:
System Disk
Configuration
Disk Backplane
Ports
HBA Port Cable Part
Number
Shorter length cable
for drives 0-3
Eight storage drives
Longer length cable
for drives 4-7
J5A1 7076125
J302 (Upper) Twelve storage drives
J301 (Lower)
J5A1 7091185
J3202 (Upper) Twenty-four storage drives
J3201 (Lower)
J5A1 7091185
b. (Optional) To reconnect the SAS cables between the front storage drive
backplane and the rear storage drive backplane, plug each cable into its
SAS connector until you hear an audible click [2].
In twelve and twenty-four drive systems, attach the SAS cable to connector (J300) on the
front storage drive backplane and to SAS connectors (RHDD0 and RHDD1) on the rear
storage drive backplane.
Note - Cable part number 7064129 is required for SAS connections between the front storage
drive backplane and rear storage drive backplane.
3.
Return the server to operation.
a.
Depending on your server's storage drive configuration, do one of the
following:
■
If your server is configured with twenty-four 2.5-inch storage drives or
twelve 3.5-inch storage drives, install the server's front fan assembly
door cover.
See “Install the Fan Assembly Door” on page 228 .