User Manual
To add to the static route to the route table of the System:
1.
Select the
Route Settings
tab on the
System > IP
General Settings
menu.
2.
Click
New Route
3.
Enter a
Route Name
for the route.
4.
In the
Destination Network/Host
field, enter the IP address of the destination network/host that
the route provides access to.
5.
Enter a value in the
Destination netmask
field that identifies the destination network or host. Any
number between 0 and 32. A subnet mask of 32 identifies a host route.
6.
Enter
Route Gateway
with the IP address of a router that will routes packets to the destination
network. This may be left blank.
7.
Select the
Interface
to use to reach the destination, may be left as
None.
8.
Enter a value in the
Metric
field that represents the metric of this connection. Use any number
equal to or greater than 0. This only has to be set if two or more routes conflict or have
overlapping targets.
9.
Click
Apply.
NOTE
The route details page provides a list of network interfaces and modems to which a route can be
bound. In the case of a modem, the route will be attached to any dialup session established via
that device. A route can be specified with a gateway, an interface or both. If the specified interface
is not active, routes configured for that interface will not be active.
