5-20
Sect
ion5
SETTINGS FOR
FUNCTIONS
ZS-HL
User’s Manual
Section5
Setting Output Processing of Sensing Information
Set the hysteresis width based on the fluctuations in the measured values around the trigger level.
The hysteresis will be applied from the start of the sampling period and will prevent timing input
chattering.
SELF-DN
The sampling period is the period at which the measured value is smaller than
the specified self-trigger level. Hold measurement is possible without a sync
input.
When SELF-DN is selected, the following items are subsequently displayed:
• TRG LEVEL
Sets the desired self-trigger level.
Range: -999.99 to 999.999
• TRG HYS
Sets the hysteresis width for the self-trigger.
Range: 0 to 999.999
When a delay time is set, the timing when the measured value
becomes greater than the self-trigger level and the end of the sam-
pling period will not be synchronous. Sampling will end after the spec-
ified sampling period has elapsed.
Setting
Description
Self-trigger level
Measured value
Sampling period
Action point
Return point
Hysteresis width
(for self-trigger)
Summary of Contents for ZS--LD10GT
