1-8
Se
ct
io
n 1
FEATURES
ZS-HL
User’s Manual
Section 1
Setting Flow
Setting Flow
Attach a Sensor Head according to the front side
material of the workpiece and the features of the Sensor.
Turn ON the power.
Installation & Connection
Switching to Multi-Task Mode
Save the Settings Data
Make sure that you always save the data after you set it.
If you turn OFF the power without saving the data, all the settings data will be cleared.
Selecting Tasks
Setting for Measurement
of Characteristic Points
Selecting the Status of Head Installation
Select either regular reflection or diffuse reflection.
Selecting Measurement Mode
Change it when the received light amount is small or when you want to increase the
processing speed. (Usually, select [HI-RESO] of the default values.)
Single-Task
Multi-Task
Section2
INSTALLATION & CONNECTION
Setting the Scaling
You can correct the display value of the measured value as desired.
Setting HOLD
Set the hold conditions.
Selecting the Measurement Object
Change it when you measure glass or mirrors. (Usually, select [NORMAL] of the default values.)
Save the data you have set.
When you select Multi-Task mode, specify the setting for each task.
Setting the Zero Reset Function
Set zero reset.
Preparation for
measurement
Setting for measurement conditions
Setting for output processing
Saving the Settings
p.2-2
p.5-14
p.5-18
p.5-22
p.5-29
p.5-8
p.5-5
p.5-6
p.5-9
p.5-24
p.5-4
Summary of Contents for ZS--LD10GT
