Se
ct
io
n3
APPLICATION and
SETTING EXAMPLES
Section3
Measuring the Thickness of Transparent Objects
3-5
ZS-HL
User’s Manual
Setting Scaling
4.
Set the actual workpiece within
the measuring range.
5.
Select [OUTPUT]-[SCALING]-[ON]-
[AUTO].
When you want to execute [SCALING FOR GLASS THICKNESS], set the workpiece within
the measuring range. In the status in which a measurement cannot be performed, you cannot
set the scaling (automatic).
6.
Enter the actual size of
the glass thickness.
Saving the Settings
7.
Set the mode switch to RUN.
8.
Select [Yes] and save the settings.
Measurement
9.
Check the measured value.
When a measurement is not stable
Select [THICK]-[MODE2] at the step 3. When you select [MODE2], the mode is switched to 2-area mea-
surement mode that executes an adjustment for suitable received light amount for the front side and
back side of the glass respectively. When you use SmartMonitor ZS, you can adjust the area while
checking the received light amount.
Setting Measurement Object p.5-9
Measuring distance
Measuring range
1
AUTO
2
MANUAL
DIG
VAL SET:OK
INPUT THICKNESS
Value
Digit
FUN
RUN
TEACH
1
YES
2
NO
I s c h a n g e s a v e d ?
Measured
value
Summary of Contents for ZS--LD10GT
