7-4
Sect
ion7
U
SB/R
S-232C COMMUN
ICATION
ZS-HL
User’s Manual
Section7
Connecting Using a USB Cable
Connecting Using a USB Cable
Connection Method
1.
Install the USB driver to a personal computer.
Installation is required only when USB is connected for the first time.
Installing the USB driver p.2-16
2.
Insert one end of the USB cable into the
USB connector of the controller.
3.
Insert one end of the USB cable into the
USB connector of the external device.
The USB cable is an accessory of the Sensor
Controller ZS-HLDC_1A. Attach ferrite cores
to both ends of the cable.
Setting the Communication Specifications
Set the communication specifications for the controller according to the communication
specifications for external devices.
X
FUN Mode-[SYSTEM]-[COM]
Setting
Range
RS-232C
LENGTH
The settings are ignored.
PARITY
STOP (STOP BIT)
BAUDRAT
DELIMIT
CR, LF, CR+LF (default: CR)
NODE (node No.)
The settings are ignored.
Ferrite core
Summary of Contents for ZS--LD10GT
