9-16
Sec
tion9
APPENDIX
ZS-HL
User’s Manual
Section9
Updating Firmware
Connecting the Controller to a Personal Computer
1.
Connect the controller to the personal
computer by the USB cable.
The USB driver must be installed when the
controller is connected to the personal
computer for the first time.
Installing the USB driver
p.2-16
2.
Turn on the power of the controller.
• Make sure that the power of the controller is connected securely. When the power is turned off while
updating, the controller breaks down and does not run normally.
• Make sure that you turn on the power of the controller only (when it is not connected to other control-
lers). If you connect two or more controllers, Warp Engine ZS does not start.
Installing SmartMonitor ZS
3.
Install SmartMonitor ZS to a personal computer.
Warp Engine ZS that is used for updating the firmware will be simultaneously
installed.
Installing SmartMonitor ZS p.2-15
Starting Warp Engine ZS
• Start Warp Engine ZS only when the personal computer recognizes the controller normally.
• When you start up ZS-MDC on its own, an error occurs in the controller. However, Warp Engine ZS
should be started up in this state.
Summary of Contents for ZS--LD10GT
