6-2
Section6
I/
O
ZS-HL
User’s Manual
Section6
Overview
Overview
By using the I/O cable and terminal block output of the Sensor Controller, you can output
the measured value or judgment result to external devices, or input a control signal such
as zero reset and LD-OFF from external devices. A predetermined I/O signal is assigned
to each signal line for the I/O cable.
I/O Cable
The I/O cable outputs the measured value or judgment value from the I/O cable of the
controller, and inputs a measurement control signal or zero reset signal.
Wiring
p.2-10
Terminal Block Output
When you connect a real-time parallel output unit, the Sensor Controller outputs the
measured value or judgment value in parallel.
Output of measured value (linear output)
Settings for Linear Output
Judgment output
Input of control signal
Settings for Judgment Output
Settings for Input Signal
p.6-3
p.6-7
p.6-17
Output the measured value (binary data) or judgment.
ZS-RPD
P
ARALLEL
OUTPUT
UNIT
RS-232C
DA
T
A
Real-time parallel
output unit ZS-RPD
Connect to the
RS-232C connector.
p.6-9
Summary of Contents for ZS--LD10GT
