Sec
tion4
FUNC
TION
S AN
D OPERA
T
ION
S
USED
DU
RING OPERA
T
ION
Section4
Zero Reset Operation
4-5
ZS-HL
User’s Manual
Zero Reset Operation
When the zero reset function is used, the reference value “0” is registered as the height
and the measured value can be displayed and output as a positive or negative deviation
(tolerance) from the reference value. In RUN mode, the measured value can be reset to 0
at any timing during measurement.
Example 1: Using the height of sensing object registered as the reference value and the
tolerance output as the measured value
Example 2: Using the height of sensing object as the measured value with an offset set to 10
Example 3: Using zero reset to measure steps in sensing object (zero reset at each
measurement)
0
-2
+2
Sensor Head
(reference value)
Sensing
object
(LOW threshold value)
(HIGH threshold value)
10
+8
+12
Sensor Head
Sensing
object
(LOW threshold value)
(HIGH threshold value)
Sensor Head
Zero reset
executed
This step
is mea-
sured.
Zero reset
executed
Zero reset
executed
Direction of movement
Summary of Contents for ZS--LD10GT
