![background image](http://html1.mh-extra.com/html/omron/fb-library/fb-library_startup-manual_744220087.webp)
2-1. Hardware Setup
Check whether communication test switch is OFF.
OFF
Set the Unit No. to 01 using flat-blade screwdriver or other tool.
Set the unit and turn the PLC ON.
Rubber hold part
Ring part
Note: Press the connector holding the rubber hold part,
as the connector is not locked when pressed
holding the ring part.
1. Hold the rubber hold part of the connector and insert
the connector in align with the key slot of the Unit.
2. Press the cable connector straight down until it fits
into the Unit.
Connect to the Read/Write Head.
Set the switches of the ID Sensor Unit as follows.
CJ1W-V600C11
2-8 RFID (ID Sensor)
V600-H
Summary of Contents for FB LIBRARY -
