Omron FB LIBRARY -, Startup Manual

Page: 38 / 162

2-7. Servo Driver Parameter Setup
Set up servo parameters for a connected servo driver.
For details of servo parameters, see User’s Manual of W series AC SERVO MOTORS/SERVO
DRIVERS.
When PLC program sends data by using "_NCF401_WriteParameter" of FB Library, but
this example shows change of external input signal assignment through the front panel.
[Notice]
Procedure
- Activate setup mode
- Configure parameter No.
- Indicate parameter value
6541 Input signal selection 5 Pn511
8883 Input signal selection 2 Pn50B
2881 Input signal selection 1 Pn50A
Setting Parameter Name Parameter No..
Set values shown above to 50B and 511 in the same manner.
This configures assignment of external input signals (input signal selection) for the servo
driver as shown below:
2-3 Position Control Unit
CJ1W-NCF71