Omron FB LIBRARY -, Startup Manual

Page: 143 / 162

2-1-4. Temperature Control Function Setting
In this example, only SW8 is set to ON to use factory default setting as it is.
Do not initialize Initialize Initialize settings in EEPROM 7
°
C
°
F Temperature units (
°
C/
°
F) 2
4-digit BCD 16-bit binary Data format
3
PID control ON/OFF control Control method
6
Reverse (heating) Forward (cooling) Control operation (loops 1 and 3) 4
Reverse (heating) Forward (cooling) Control operation (loops 2 and 4)
5
ON Do not transfer Transfer Transfer settings in EEPROM
8
OFF
Stop Continue Operation when CPU unit is in
PROGRAM mode
1
Factory
setting
OFF ON Function SW No.
ON at right
Switch function and factory settings
2-1-5. Wiring of thermocouple
Connect the wiring based on the following terminal assignment.
To use Loop 1, connect the thermocouple to Input 1 and the control target output to Output 1.
* Do not connect any cable to the N.C terminal
2-1-6. Power On
Turn the PC main unit on. Hardware setting described in the chapter 1 must be done
when the power is turned off. After power on, SW settings are read (SW settings are
read only at power on) .
2-1-7. Creating I/O Table
Connect CX-Programmer (Online) when creating I/O table.
2-13 Temperature Control Unit
CJ1W-TC001/101/003/103/002/102/004/104