31
Adding and Deleting Servo Drives
Section 4-3
3.
Select the Series.
Click the drop-down list and select an appropriate series.
Note
Select
OMRON W Series
when using an OMRON R88D-WT
@
W-
series Servo Drive with a Yaskawa JUSP-NS115 MECHA-
TROLINK-II Application Module. Select
OMRON W Series (Built-in
Communications)
when using an OMRON R88D-WN
@
-ML2 W-se-
ries Servo Drive with Built-in MECHATROLINK-II Communications.
Select
OMRON SMARTSTEP Junior with Built-in Communications
when using an OMRON SMARTSTEP Junior Servo Drive with
Built-in MECHATROLINK-II Communications (R7D-ZN
@
-ML2).
Select
OMRON G Series (Built-in Communications)
when using an
OMRON G-series Servo Drive with Built-in MECHATROLINK-II
Communications (R88D-GN
@
-ML2).
4.
Select the Servo Drive
Model.
Click the drop-down list and select an appropriate Servo Drive model. The
Servo Drive models in the list depends on the selected Series.
5.
Select the Version.
Click the drop-down list and select an appropriate version. The Servo Drive
versions in the list depends on the selected Servo Drive model.
6.
Set the Axis No.
Click the drop-down list and select an axis number. The axis numbers that
are already in use will not be displayed.
7.
Enter the Comment.
Up to 256 one-byte characters can be entered. The comment may be omit-
ted.
8.
Click the
OK
Button.
A new Servo Drive will be added to the Position Control Unit.
Copying Servo Drives
to Position Control
Units
If a Servo Drive that has been registered under a Position Control Unit in the
Axis Map Setting Window is copied and pasted on the same Position Control
Unit, a new Servo Drive will be added with the lowest axis number that is not
in use. If a Servo Drive that has been registered under a Position Control Unit
is copied and pasted on another Servo Drive (which must be registered in
advance), the parameters of the copied Servo Drive will overwrite the other
Servo Drive.
Deleting Servo Drives
from Position Control
Units
A Servo Drive that has been registered under a Position Control Unit can be
deleted.
Summary of Contents for CX-MOTION-NCF - V1.8
