18
Basic Operation
Section 3-2
Starting CX-Motion-NCF Using
Start Special Application - Start Only
from the I/O Table Window
Opened from the CX-Programmer That Was Installed from the CX-One
Right-click a Position Control Unit in the I/O Table Window and select
Start
Special Application - Start Only
from the pop-up menu. The following win-
dow will be displayed with a new project.
Starting CX-Motion-NCF
from Windows Start Menu
Select
Start -
Programs - OMRON - CX-One - CX-Motion-NCF - CX-
Motion-NCF
. The same window as when selecting
Start Only
will be dis-
played with a new project.
Quitting CX-Motion-NCF
1,2,3...
1.
Select
File - Exit
or click the Close Button at the top right corner of the win-
dow. After editing a project, if the project has not been saved, the following
dialog box will be displayed.
2.
Click the
Yes
Button to save the changes made. Click the
No
Button if it is
not necessary to save the changes. Click the
Cancel
Button to return to
the Basic Window without quitting the CX-Motion-NCF.
Summary of Contents for CX-MOTION-NCF - V1.8
