Omron CX-MOTION-NCF - V1.8, Operation Manual

Page: 84 / 138

63
Comparing Data Section 7-5
6. If the connection was established in step 4, the connection status can be
restored (released in this case) here. To release the connection, click the
OK Button. To leave the connection established, click the Cancel Button.
7. After completion of uploading Unit and Servo Parameters, they are com-
pared with the parameters on the personal computer. If they match, the fol-
lowing dialog box will be displayed.
If there is any mismatch in the comparison, the following window will be
displayed to show the parameters that did not match.
Note When the MECHATROLINK communications cannot be started, batch com-
paring cannot be executed. Start the MECHATROLINK communications first
and execute batch comparing.
7-5-2 Comparing Unit Parameters
1,2,3... 1. Click the Compare Button in the Edit Unit Parameter Window. The follow-
ing dialog box will be displayed.