67
Writing to Flash Memory
Section 7-6
3.
Click the
OK
Button.
The following dialog box will be displayed to confirm whether to restart the
Position Control Unit or not. To enable the Unit Parameters written to the
flash memory, the Position Control Unit must be restarted.
4.
If the connection was released in step 2, the connection status can be re-
stored (established in this case) here. To establish the connection, click the
OK
Button. To leave the connection released, click the
Cancel
Button.
5.
The writing operation is completed when the Write to flash memory win-
dow is no longer displayed.
Note
If an error occurs in writing to the flash memory, the Unit Parameters may not
be written to the flash memory successfully. In this case, write the Unit Param-
eters to the flash memory again after resetting the error.
Summary of Contents for CX-MOTION-NCF - V1.8
