62
Comparing Data
Section 7-5
3.
Click the
OK
Button. Uploading Unit Parameters from the Position Control
Unit will start. Clicking the
Cancel
Button will cancel the upload.
4.
If the communications between the Position Control Unit and Servo Drive
are not established at this point, the following dialog box will be displayed
to confirm whether to establish the connection or not.
5.
Click the
OK
Button to establish the connection and start uploading Servo
Parameters from the Servo Drive.
Clicking the
Cancel
Button will cancel the upload.
If the connection cannot be established at this point, the following dialog
box will be displayed. Click the
OK
Button and the axes registered in the
Position Control Unit will be displayed as Unknown Model in the Axis Map
Setting Window.
Summary of Contents for CX-MOTION-NCF - V1.8
