Omron CX-MOTION - 06-2008, Operation Manual

Page: 118 / 135

99
Troubleshooting Section 15-1
17 Number Specification Error A number-related operand (e.g., operands 'C', 'E', and 'S') has
exceeded the limit.
Examples: @Operand 'C' for WORK, OFFPOS, Operand 'S' or
'E' for CAM, CAMBOX
18 Specification Error in Number of Times An operand related to number of times and data numbers
(operands 'L' or 'N') has exceeded the limit.
Example: @PARALLEL N <Number of branches>, SFTR,
SFTL N <Shift amount>
19 Mode Error A mode-related operand (operand 'Q') has exceeded the limit.
Examples: Operand 'Q' for MOVELINK, CAMBOX.
20 Immediate Value Range Exceeded An immediate value range (-2147483648 to 2147483647) or
digit number (10-digit) has overflowed.
21 Illegal Variable Data Type A variable that cannot be used in commands or a substitutions
has been defined.
A data type that cannot be used in commands or substitutions
has been defined.
A variable ('S', 'C', an indirect specification, of OW0300 to
OW0AFF) that cannot be on the left side of a substitution has
been set.
A variable that cannot be written in the operand 'W' for FOR
has been set.
A variable that cannot be written has been set for the variable
to edit for XFER, CLEAR, SFTR, and SFTL.
The data type character of a variable was not B, W, L, or F.
22 Variable Address Range Exceeded Neither hexadecimal operand parameters nor axis parameter
values have been set.
The hexadecimal digit number has exceeded eight digits.
The acronym followed by #, @ was not S, M, C, O, T, A, or I.
The hexadecimal digit number for a bit variable was not five
digits.
The hexadecimal digit number of variables other than bit vari-
ables was not four digits.
An odd-numbered address was set for the variable S, O, M, C,
or I.
The maximum value of the variable addresses has overflowed.
The individual data types of variables have exceeded the max-
imum value.
23 Illegal Expression Multiple terms have been used in an operation command.
24 Illegal Nesting The number of nesting levels of IF-ELSE-ENDIF exceeded the
limit.
The number of nesting levels of FOR-NEXT exceeded the
limit.
The number of nesting levels of WHILE-WEND exceeded the
limit.
25 Illegal Subprogram Specification num-
ber Specification of operand 'P' value at the subprogram's SUB
command is higher than 1000 or lower than 499.
26 Radius Specification, Multi-circumfer-
ence Specification The operands 'R' and 'L' were specified simultaneously for the
MOVEC command
27 No Description
28 Sync Trailing Axis Specification Error More than two of the same axis numbers have been set in one
block.
29 NSTOP/INC/ABL Duplication Error Commands are overlapped as the result of repeating the
same command, such as NSTOP-NSTOP, INC-INC, ABL-ABL.
Error code Description Detailed description