![background image](http://html1.mh-extra.com/html/omron/cs1w-hca12-v1/cs1w-hca12-v1_operation-manual_741977061.webp)
41
Installation
Section 3-2
3.
To remove the Unit, loosen the screw at the bottom of the Unit before dis-
mounting.
Note
Provide the space shown in the diagram below to enable mounting and dis-
mounting.
3-2-3
Handling the Unit
• Be sure to turn OFF the power supply to the PLC before mounting or dis-
mounting the Unit, or performing wiring.
• To reduce the influence of noise, do not run I/O signal lines in the same
ducts as power cables or lines carrying high voltages.
• To prevent the wire cuttings that are scattered during wiring from entering
the interior of the Unit, leave the label attached to the top of the Unit when
performing wiring. After wiring has been completed, remove the label to
allow proper heat dissipation.
Duct
20 mm min.
Backplane
20 mm min.
Phillips screwdriver
Duct
Summary of Contents for CS1W-HCA12-V1
