Omron CS1W-HCA12-V1, Operation Manual

Page: 88 / 254

68
Words Allocated in DM Area
Section 4-3
4-3-2 DM Area Allocation Details
Initial Setting Area (m to m+9)
Word Bits Function Contents
Setting Condition
m 00 to 07 RUN/STOP
command
enable/disable
and operating
mode at startup Operating mode at
startup Operating mode
specification after
startup Operation for error
at PLC (SR 24915
turns ON)
00 Hex RUN/STOP
command
enabled Determined by the status of the RUN/
STOP Command Bit (n, bit 00). The
operating mode can be switched
between RUN mode and MONITOR
mode using the Programming Device
connected to the Customizable
Counter Unit. The RUN/STOP
Command Bit (n,
bit 00) turns OFF
and Customizable
Counter Unit oper-
ation stops.
Note: There are
errors for which
the RUN/STOP
Command Bit may
not turn OFF. For
details, refer to
9-3
Troubleshooting
Tables
.
01 Hex RUN/STOP
command
disabled Determined by the
operating mode
specification of the
Programming
Console.
Note: If there is no
Programming
Console con-
nected or if the
Programming
Device connec-
tion switch on the
front of the Unit is
set to OFF, the
mode is automati-
cally set to RUN
mode.
Determined by
commands from
the Programming
Device (CX- Pro-
grammer or the
Programming
Console).
Note: The RUN/
STOP command
(n, bit 00) is dis-
abled.
Customizable
Counter Unit oper-
ation continues.
02 Hex PROGRAM mode
03 Hex MONITOR mode
04 Hex RUN mode
08 to 15 (Reserved by system.) ---