![background image](http://html.mh-extra.com/html/omron/c200hw-clk21/c200hw-clk21_operation-manual_742483265.webp)
240
Remote Programming and Monitoring
Section 7-2
7-2
Remote Programming and Monitoring
A remote PLC can be programmed and monitored across a network from a
Programming Device connected to a PLC.
7-2-1
Local Networks
SYSMAC Support Software and CV Support Software
A Programming Device connected to a C200HX/HG/HE, CVM1, or CV-series
CPU Unit can program and monitor a C200HX/HG/HE, CVM1, or CV-series
PLC on the same network. Programming and monitoring are possible, how-
ever, only for the same type of CPU Unit as the one to which the Programming
Device is connected. For example, if the Programming Device is connected to
a CVM1 or CV-series PLC, you can only program and monitor CVM1 or CV-
series PLCs on the network.
SYSMAC Support
Software
Programming Device
Programming
and monitoring
SYSMAC Support
Software (CVM1 only)
or
CV Support Software
Note
A factory automation node computer cannot remotely program or
monitor. The node can only monitor Controller Link Network status.
Controller Link Network
C200HX/HG/HE
Controller Link Network
Programming Device
Programming
and monitoring
CVM1, or CV-series PLC
CVM1, or CV-series PLC
Controller Link
Support Software
C200HX/HG/HE
Summary of Contents for C200HW-CLK21
