![background image](http://html.mh-extra.com/html/omron/c200hw-clk21/c200hw-clk21_operation-manual_742483015.webp)
xvi
Section 3
describes how to install a Controller Link Unit and how to wire the Controller Link Network.
Details are also provided on installation, wiring, and basic operating procedures of Repeater Units,
including information on using them to construct networks.
Section 4
describes the settings required for starting communications. These basic settings are
required for both data links function and the message service. Carry out the settings described here
before turning on power to the Controller Link Unit.
Section 5
describes how to use data links in a Controller Link Network. Refer to
for an outline of data link application.
Section 6
explains how to use the message service provided by a Controller Link Unit. It also explains
the FINS commands and responses supported by Controller Link Units and those supported by
C200HX/HG/HE, CS/CJ-series, CVM1 and CV-series PLCs.
Section 7
describes the method used to connect multiple networks through CS/CJ-series, CVM1, and
CV-series PLCs. The section also describes remote programming and monitoring with Programming
Devices.
Section 8
explains details on Controller Link Network communications. Refer to this section for net-
work communications that require accurate communications timing.
Section 9
provides information on troubleshooting errors that occur during Controller Link Unit opera-
tion, as well as daily inspection, cleaning, and other maintenance procedures.
Section 10
provides information on functions that can be performed without turning OFF the PLC
power to the existing network, such as adding nodes to the Controller Link Network using a Repeater
Unit and changing data link tables while the data links are active.
Appendix A
provides a list of standard OMRON products related to Controller Link Networks.
Appendix B
provides easy reference to the words in PLC memory areas used by Controller Link Net-
works.
Appendix C
provides information on how to use the CJ1W-TB101 Wired Controller Link Unit Relay
Terminal Block, including details on connection and replacement.
!WARNING
Failure to read and understand the information provided in this manual may
result in personal injury or death, damage to the product, or product failure.
Please read each section in its entirety and be sure you understand the infor-
mation provided in the section and related sections before attempting any of
the procedures or operations given.
Summary of Contents for C200HW-CLK21
