![background image](http://html.mh-extra.com/html/omron/c200hw-clk21/c200hw-clk21_operation-manual_742483064.webp)
39
Data Links Procedures
Section 2-1
• 1:N allocation (Compatible with CS1W-CLK21-V1, CS1W-CLK23,
CJ1W-CLK21-V1, and CJ1W-CLK23)
Common Type
Note
For automatic data link creation with 1:N allocations, use the CX-Net
in CX-Programmer version 3.2 or higher.
Contents
Method
Nodes
Page
a. Set the data link mode
to automatic.
Use Support Soft-
ware for the PLC
including Program-
ming Console (see
note).
Data link startup
node only
The node that is used
to start the data link is
called the startup
node. It is necessary
to decide beforehand
which node will be
the startup node.
b. 1:N setting
Data link startup
node only
Area
1
c. Set the area
Data link startup
node only
Only when Area 1 is
used
d. Set the data
link start word
e. Set the number
of send words
per master
node
f.
Set the number
of send words
per slave node
Area
2
g. Set the area
Data link startup
node only
Only when Area 2 is
used
h. Set the data
link start word
i. Set the number
of send words
per master
node
j.
Set the number
of send words
per slave node
k. Set the first data link
status word
Data link startup
node only
l. Set the nodes to par-
ticipate in the data
links.
Data link startup
node only
Summary of Contents for C200HW-CLK21
