4
Overview
Section 1-1
Maximum 62-node Configuration
The following Controller Link Units/Support Boards must be used to construct
a network with more than 32 nodes:
CS1W-CLK23
CS1W-CLK21-V1
CJ1W-CLK23
CJ1W-CLK21-V1
3G8F7-CLK23
3G8F7-CLK21-V1
Note
1.
The network will not operate correctly unless all nodes within the network
use the above Units/Boards.
2.
Only node addresses 1 through 32 can be used on networks for which 62
nodes have not been enabled.
Connecting Repeater
Units Using H-PCF Optical
Fiber Cable
CS-series and CVM1/CV-series PLCs only.
Token Ring Mode
Wired Controller Link Unit
Wired Controller Link Unit
Twisted-pair cable
31 nodes max.
Twisted-pair cable
31 nodes max.
CS1W-RPT01
Repeater Unit
C
P
U
C
P
U
C
P
U
C
P
U
CVM1/CV-series PLC
CS-series PLC
Backup
power supply
(24 V DC)
Personal computer
3G8F7-CLK12-V1
Controller Link Support Board
for PCI Bus (token ring mode)
H-PCF Optical fiber cable
(ring connection)
CS1W-CLK12-V1
Controller Link Unit
(token ring mode)
CVM1-CLK12
Controller Link Unit
(token ring mode)
CVM1-CLK12
Controller Link Unit
(token ring mode)
CS1W-CLK12-V1
Controller Link Unit
(token ring mode)
CVM1/CV-series PLC
CS-series PLC
Summary of Contents for C200HW-CLK21
