EN-6
RANGER
®
7000 SCALES
2.2
Installing Components
Refer to the illustrations and instructions below to identify and assemble your Ranger 7000 scale with its
components. All components must be assembled before using the scale.
2.2.1
Terminal Setup
When the Ranger 7000 is delivered, the Terminal is already attached (docked) to the Base. No additional setup is
necessary. Refer to the illustrations and instructions below to identify and assemble your Ranger 7000 Scale.
Note:
The Terminal is identical for all Ranger 7000 Scale models.
2.2.2
Installing the Wind Ring, Weighing Platform
1. Place the Wind Ring in position
(R71MHD3, R71MHD6).
2. Place the platform onto the
spider.
2.3
Selecting the Location
Avoid excessive vibrations, heat sources, air current, or rapid temperature changes. Allow sufficient space.
Note:
Interface cables connect to the terminal. The terminal can be detached and mounted on a wall or
positioned on a table separate from the scale.
2.4
Connecting Power and Turning ON the Scale
The Ranger 7000 comes with an AC power cord. Connect the power cord to a suitable grounded electrical outlet
and press the ON button on the side of the base (see figure below).
Power ON button on the side of the base
Attention:
Allow equipment to warm up for 60 minutes for optimal weighing performance.
Power ON Button
