Oce Arizona 600, User Manual

Page: 15 / 148

Product Description
12/9/04 1-3
conventional internal take-up roll mandrel. The EMTU contains a holder for
either component that is not in use (see Figure 1-1).
Figure 1-1 Print & Go Roller or Mandrel Holder
Firmware changes that accommodate the Print & Go feature present a few operational
changes, including:
• Whenever the ADVANCE MEDIA button is used to reposition the media, no
readjustment of the position occurs at the beginning of the next print. The
effect of this button is the same as if the user pressed the CANCEL button to
terminate the ADVANCE MEDIA function.
• Océ strongly recommends that only a small amount of media be rewound
using the ADVANCE MEDIA button because the exposed media may not
track smoothly back through the printer.
• When loading media in Print & Go mode, the operator can ignore the take-up
roll diameter question because that diameter is not used.
• The MEDIA USED value (feet/meters) is not displayed on the control panel.
• Every print should pass through the dry cycle to prevent wet ink from
offsetting onto the lower black roller. If another print is in the queue prior to
a print being cancelled, the operator is given the option to continue drying or
to cancel the print and allow the next image to begin printing.
Important: If the operator cancels a print before the drying cycle is complete, the media
must not be advanced. Otherwise, ink will be transferred to the lower black
roller.
Print & Go
Roller Holder