Oce Arizona 600, User Manual

Page: 33 / 148

Roll-to-Roll Media Installation
12/9/04 3-5
3.3
Roll-to-Roll Media Installation
Successful media installation is dependent on several factors, including:
• Centering/alignment of the supply media roll on the supply mandrel
• Matching lengths of the supply and take-up cores
• Aligned installation of the supply and take-up cores on the supply and take-up
mandrels
Inexact installation may result in media encoder errors, the misreading of the media width,
media rippling and/or head strikes.
3.3.1
Installing Supply Media
Océ Display Graphics Systems recommends cleaning the media drive roller after each roll
of media (see Figure 3-11 on page 3-9 and "Media Drive Roller" on page 5-3).
Follow the steps below to install a new supply media roll:
1. Install the supply media on the mandrel (see Figure 3-3 on page 3-3), ensuring that
the media is centered (see Figure 3-4 on page 3-4) and secure the locking hubs.
2. Lower the mandrel assembly support arms on both sides of the frame and place the
mandrel/media assembly into the machine (see Figure 3-5). Make sure the mandrel is
seated properly on the gear and steel rollers (see Figure 3-6 on page 3-6)
.
Figure 3-5 Mandrel/Media Assembly on the Support Arms