Oce Arizona 600, User Manual

Page: 81 / 148

Operator
12/9/04 4-23
This feature enables the adjustment of media stepping to compensate for variation
in media lots and environmental factors. The plus direction lengthens each media
step. The minus direction shortens each media step.
13. Press ACCEPT. You then see:
MEDIA MENU
hor margins: (0.2" - 4.0")
Use the +/- buttons to select the required horizontal margin value for a job.
14. Press ACCEPT. You then see:
MEDIA MENU
ver margins: (0.2" - 4.0")
Use the +/- buttons to select the required vertical margin value for a job.
15. Press ACCEPT. You then see:
MEDIA MENU
[media name]
Media Type: Other
Selecting OTHER enables additional menus for manual setup. When changing values,
holding the +/- buttons continuously increments or decrements the value repeatedly. Follow
the steps below for this media type option:
1. Navigate to:
MEDIA MENU
Other
2. Press the ACCEPT button. You then see:
MEDIA MENU
thickness: (2.00 - 30.00) mil
The range for thickness values is 2.00-30.00 mils. The media thickness is typically
on the media container label, if any. The media thickness changes by .05 mils.
Use the +/- buttons to increment or decrement the thickness setting.
3. Press ACCEPT. You then see:
MEDIA MENU
takeup core OD: (3.10" - 4.00")
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.