Measure Media Thickness
Use a digital slide caliper or micrometer to accurately measure the media
thickness of the media. An error in measurement of media thickness will
affect bi-directional alignment and can contribute to the amount of
graininess in the printed image or cause a carriage/printhead crash with
the media.
Set the Printer to Flatbed
Select the Flatbed button on the toolbar to prepare the printer. This is
required only when the printer is initially started, or if it is reset due to an
error condition.
Select Job To Be Printed, Check Print Parameters And Verify Media
Thickness
Click on the job to be printed from the active job list to select it. After it is
selected the parameters on the job information and parameters panel will
be displayed and may be modified if desired. Refer to the section
Graphical User Interface Display for details on what is displayed and how
to modify the job information.
Select Print Icon, Print Mode, and Confirm Media Thickness
When you select the Print toolbar icon it will gray-out the icon and the
hand icon to the left of the job to be printed will turn green.
When printing Flatbed mode and Flatbed icon on the command toolbar is
not selected, select it. Similarly, if printing in roll mode and the Roll icon is
not selected select it.
The print job's icon should change to red/orange, and also the Pause icon
and Confirm thickness buttons should appear in the command toolbar
right beside Media thickness field.
Enter the measured media thickness value in indicated measurement units.
Select the 'Confirm thickness' button.
Prepare Media for Printing
Place And Register Media On The Printer Vacuum Table
Place the media on the table in the orientation that matches the job to
printed and register the media to the print origin. In the next section there
are more details on how to perform the following actions.
How to Set Up a Print Job
Chapter 5 - How to Operate Your Océ Arizona Printer
89
User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
