Procedure
1.
Add your image to the active print job queue and then select it.
2.
Enter 2 or more copies in the Job Parameters Copies field.
3.
Click on the Origin pull-down menu and select Dual Origin to make it
active.
NOTE
When Dual Origin is selected, a scaled view of the image appears on the
screen preview in Zone A and a bounding box that represents the image
appears in Zone B. Both images are displayed at their respective origin
points. If you move the primary image in Zone A to a new origin (enter
new offsets), both images will then print from that changed relative origin
point. The red cross-hatched area is a reminder that it is not possible to
print in the Center zone when dual origin is selected.
4.
Place media in Zone A, mask off any unused areas, and then turn On the
vacuum.
5.
Press the Start button to begin the print in Zone A.
6.
Place media in Zone B, mask off any unused areas, and turn On the
vacuum. The printer will pause over the Center Zone after the Zone A print
is complete and then start to print in Zone B.
NOTE
The printer will not print in Zone B if the vacuum is not On. It will display
"Waiting for Table Vacuum" and wait in the Center Zone until the vacuum
is On and then will also require that you press the Start button. The
vacuum must be cycled Off and then On again in alternating zones before
the next print will begin while Dual Origin is enabled.
7.
If additional copies of the print were indicated in Step 2, then repeat Steps
5 to 7 (in alternate zones) for the total number of prints required.
How to Print With Dual Origins
Chapter 6 - How to Operate the Océ Arizona 400 Series XT
111
User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
