How to Print on Roll Media
Introduction
To print an RMO image, media must be loaded and the RMO initialized.
Use the Print Job module and the Roll Media Manager to prepare and start
the print job.
How to Print on Backlit Media
If your roll media is transparent or opaque and you are going to backlight
the image and you want to increase the density, set Quality mode in
ProductionHouse. Then click on the Quality parameter in the Print Job
menu and select Quality-Density before you initialize the job. This mode
increases the density of ink for this image as it prints and therefore
improves the appearance of backlit images.
IMPORTANT
The red Emergency stop buttons do NOT stop the media transport when
you print on roll media (they only stop gantry and carriage movement). If
you encounter a situation where the roll media runs continuously without
operator input, the only recourse is to shut off the printer's AC power
switch.
Procedure
1.
Click on the Roll icon in the menu bar of the Job Control module to disable
the RMO print queue (this allows you to check media parameters before
the job actually prints in case the job was not given a Hold status when it
was generated in Onyx ProductionHouse).
[73] Roll Icon
2.
In the Print Job Control module, transfer a print job from the ONYX
Workflow software.
3.
Click on the Roll Manager icon to enter the Roll Media Manager dialog
window.
How to Print on Roll Media
136
Chapter 7 - How to Operate the Roll Media Option
User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
