How to Unload and Remove Media
Introduction
This section explains all of the actions associated with how to cut and
unload media when there is still some media left on the supply roll.
Unload Media Summary
The following actions are associated with unloading media:
• A) Initiate Unloading
• B) Cut the Media
• C) Remove Media from Take-up Shaft in Printer or Remove Take-up
Shaft
• D) Remove Supply Shaft From Printer
• E) Remove Media Roll Or Empty Core From Media Shaft
Before you begin
NOTE
When you select the Unload icon the media will advance automatically by
a preset amount. This distance is determined by the Move Media on
Unload value in the Settings Roll Module tab. The default value will
advance the media to a position past the Media Cut Guide so that the
printed image is not cut. To manually increase this distance you can use
the foot pedal to advance the media, but only before the Unload is
selected. Once Unload is selected the foot pedals will not work until you
Initiate a new RMO pint job.
Required tools
5mm hex key
Procedure
1.
Click on the Roll Manager icon to bring up the Roll Media Manager.
2.
Select the Unload icon in the Roll Media Manager to release the tension.
3.
Cut the media using the cutter guide.
4.
Click on OK to proceed.
5.
If you want to remove the printed images without removing the take-up
roll from the printer you can press the left pedal to rotate the take-up
media shaft in the reverse direction. You can then roll up the media by
hand as it comes off the take-up roll.
How to Unload and Remove Media
132
Chapter 7 - How to Operate the Roll Media Option
User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
