[69] Cut the media at an angle
5.
Tape the pointed end of the media to the take-up core as shown below.
[70] Tape media to core
6.
Remove the tape you used to hold the media to the platen.
7.
Select the "Initialize" icon from the Roll Media Manager to prepare the
RMO for printing.
8.
After initialization has completed, advance the media until the cut area is
wound onto the core across the width of the roll and verify with the ruler
that the supply and take-up edges are at the same location.
NOTE
Important:
Use the supplied ruler to check that the edge of the take-up roll
is aligned within 1mm of the feed roll.
9.
Start an RMO print job and verify image quality and that there are no
wrinkles or banding.
Loading the Media - Alternate Method
Chapter 7 - How to Operate the Roll Media Option
131
User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
